YAOBLUESEA 200x30cm Auto Car Headlight Taillights Tint film Self Adhesive Vinyl Wrap Sheets Black

I've done a few things now with vinyl wrap and must admit I struggled with this stuff, when applying it stuck well, when heated it was to flimsy and creased very easily with that in mind other vinyl you could unstick reapply and the crease could be ironed out, this howether does not work that way at all, i didn't use the plastic scraper supplied but used a professional vinyl fabric coated applicator even this marked the vinyl and left scratches so must be a very cheap vinyl. Doesn't look to bad from a distance but be warned you need patience

The product is good but I received a roll that was half the length described in the listing

The film was cheap and it shows. It's impossible to squeegee bubbles out as the film scratches immediately, even using a felt block or microfibre towel. I tried using my finger to push out creases but had no luck (this also covered the film in scratches, albeit less obvious ones). Because of this & the fact the film isn't air releasing it's impossible to get a good finish, with or without lots of heat. Only positive is the knife you get with the kit!

My second attempt with this product as completely screwed it up first go. Having never done tinting before I found it difficult first time but soon got the hang of it. My advice would be to use soapy water on the film and surface, use a good squeegee that has material on the end, and to use heat! You will mark the film but just take the final layer off as you trim. Heating and stretching is the key to making this product work. And a bit of patience.

Spot on, worked very well. Im no expert on doing this but managed to do my lights with no creases or bubbles.Tip is to remember that there is 3 layers to the film and the soapy water method with a heat gun works a treat to stretch the film.

i bearly had 100cm put of 200cm

Not as easy as you'd think but good when you get it done.

Looks good on but had to remove. I just couldnt get it on properly. Think i will have to do my lights in 2 parts