ELEGOO 3D Printer Enclosure, Fireproof and Dustproof 3D Printer Cover Constant Temperature Tent for Neptune 3 Pro/Neptune 4/Neptune 4 Pro/Ender 3/Ender 3 V2/Ender 3 S1/Kobra 2

Setup...Elegoo Neptune 4 pro, Sovol filament dryer. Assembly is straight forward, put the pieces together as instructed....some rods are bigger/ smaller so pay attention. Getting the tent over the assembled cage takes adjusting here and there, but it fit perfectly. Getting the printer in was awkward but doable. I originally had my filament dryer outside, and would just remove whatever filament I was using into the enclosure. But, sliding the printer to the front as far as I could, allowed me room to put the dryer at the rear of the enclosure and run the filament out of it and up over the filament holder directly into the printer. There is enough room for the max rearward movement of the bed. As the dryer has a 12 hour time limit, the large velcroed door on the left side gives enough room to reach the controls and adjust. Overall very pleased.The stand is for a fishtank, with adjustable feet for leveling and a piece of 3/8 particle board on top to have room for the enclosure. Leveling it all out was pretty easy.

I specifically bought this for my Elegoo Neptune 3 Pro because of the advertised dimensions. I wanted it to be wider than it is deep, and it should (barely) fit that way. The image above shows incorrect dimensions: The height is correct, but the width and depth are reversed. The product is actually deeper than it is wide. The printed insert shows the correct dimensions. See the associated photos.I’ll make it work by moving its table away from the wall several more inches, but that means losing a couple of square feet of floor space. The quality seems perfectly fine, but I’m disappointed by the incorrect dimensions. Hopefully, the seller will correct this.Edit 6/24/24:The seller immediately corrected the mistake and contacted me, offering a couple of options to make it right. The enclosure is currently in use and working quite well. I’m also very happy with my Neptune 3 Pro, and the Elegoo filament that I’ve been using. I appreciate their quick response. Great products, and great customer support. Changing to 5 Stars.

This is a must have, keeps the printer temperature accurate and constant which means much better quality prints! Virtually eliminates noise, keeps the odor under control and keeps the print filament dry from humidity.

First, this is just a generic indoor grow tent that has elegoo branding on it, which is why it has a random Velcro side window. Nothing wrong with that, it's cheap and does what it needs to do. My issue with it is that with the printer in the enclosure and during long prints (atleast with my base model neptune 4) the entire printer tends to overheat. I'm printing the honeycomb storage wall panels slowly, back to back to back at 40mm/s with PETG and the first 2 panels came out perfect with no stringing or layer shifts. It's printing panel number 3 and man.. the quality has taken a dive and the entire base of the printer that houses the boards and power supply is ROASTING. I ended up opening the enclosure as much as I could and trying to get some cooler air to the bottom of the printer and once I did that the print started normalizing again.

This took maybe 10min to assemble with slide fit framing. Fit to frame is tight - I turned the front edges inside out then slid them over. Fit is perfect. What else is there to say? Same price as a generic one.

Excellent product and a perfect fit

This fit my Neptune 3d printer perfectly and keeps out dust.

while bigger than expected due to the size of my printer, but it works great.