Aqua-Rite Thermistor AS32 2R025.( Pack of 2) Inrush Current Limiter 2 Ohm Ohm ±25% 1.18" (30mm)

These worked great, Soldered them in and it fixed my issue. Would recommend. It is still working after a year of usage

I'm in Florida and my SwimPure control panel gets a lot of that direct sun throughout the year. I'm not sure if heat shortens its life, but I replaced this component about 3 years ago, and it failed again. It is an easy swap if you have mediocre soldering skills (there's plenty of room to work if your hands are a little shaky). Replaced it and it's working again. $9 repair. Worth it vs buying a new board! Woo!

It's hard to capture my Aquarite GLX-PCB-RITE circuit board symptoms, but essentially they were sporadic. Lights would turn on, then turn off, and occasionally turn back on again and off. Sometimes this would be triggered by switching from Super Chlorinate to Auto, sometimes not. It was frustrating. The GLX-PCB-DSP (display) never seemed right, either, in that it wouldn't read salt levels or try to calibrate to salt levels. Basically I was getting funky readings, though other settings on the display seemed normal. I did try to replace the display with a knock-off brand - didn't resolve. I tried a knock-off control board, too - it didn't resolve the issue, though logically, it should have. Maybe a bad board or connection somewhere(?) It was set to the correct cell type, but oh well, returned both for refunds.So I bought this Thermistor (x2) as I've run across a lot of similar symptoms to my issue online. Also bought a $20 solder kit. Never soldered before, and it probably took me longer than it should have to remove the old Thermistor, but it wasn't a difficult swap and got this guy soldered in after a few minutes. Connected the old circuit board back up and it worked beautifully! Had to change the cell settings but otherwise it was great. Lights are working and not cutting out like before. It read and allowed me to set my salt levels. No issues so far! Extremely pleased.

Pool repair

Aqua-Rite Thermistor AS32 2R025.( Pack of 2) Inrush Current Limiter 2 Ohm Ohm ±25% 1.18" (30mm)wrong one for me

this self-repair saved me hundreds of dollars

My pool guy was going to charge $300 to replace the circuit card on my chlorinator control box. The circuit card is $150 and an easy 5 minute swap that anyone can do. If you can solder, or knows someone who can do it for you, then it will cost you $13 and 15 minutes, plus you have a spare for next time. I have replaced this same part 3 times in the last 16 years so it does last and is a lot better than replacing the card 3 times. The replacements have lasted just as long as the original which is about 5 years. This is the only part that has failed on my control panel to date...knock on wood.

I have the Aqua-Rite Goldline salt system. The thermistors burn out every 2-3 years. Just spending about 1/2 hour desoldering the old and soldering in the new thermistor has saved me thousands of $$$.