Ender 3 Heated Bed with Cable 24V 220W Compatible with Creality Ender 3, Ender 3 Neo, Ender 3 pro, Ender 3 V2, Endder 3 V2 Neo, Voxelab Aquila X2 3D Printers

Works great! Easy hookup no complaints

Normally to lazy to write reviews but will on this. looks identical to original except has the stick on pad for the bottom side to keep heat in and seems to distribute heat more evenly. am happy with it easy install and leveled perfect. I would suggest this to others after original warps to point it messes up prints.

I bought this to replace a heated bed for a Creality CR10-S. The cable on the original part was damaged from years of use and had been repaired more than once.The new bed looks and fits like the original part and eliminated thermal runaway/"Killed" error messages.My experience with 3D printing is that no printer bed, especially when they are this size, is perfectly flat. I use borosilicate glass on the print bed, which also changes the plane. Having said that, I don't see any glaring problems with the trueness of this this part.If I had it to do over, I would buy this part again.

I was having a heck of a hard time getting things to stick to my old bed. eventually degraded all the way to using a non-contact thermometer and found I had a spot or 3 that were as much as 5°C colder than the rest of this bed. anyhow, this replacement was a perfect direct fit for my Ender 3 printer. I ended up adjusting the temperature down in my slicer a bit... more proof that the old bed was having issues. I'd reccomend this build plate.

Direct replacement of my aged heated bed. Very easy to install. Heats up evenly and maintains a good temperature.

Tested for 30 days and no issues.Flat surface.No complaints!

After trouble shooting for weeks on Abnormal Temp failures on a S1 Pro, I finally cut the bed wire sheath apart and found a broken ground wire on my original bed. Outside of wire sheath looked perfectly fine but after removing sheath I finally found the problem. This bed is plug and play except it doesn’t have a ground wire. I drilled the back edge (where my original was) being careful not to drill into the heating area. Then I threaded it for a 8-32 tiny bolt. I also added insulation to the bottom of the bed and ran the wiring through some loom I already had. My printer is up and running again. I’d give 5 stars if it came with a ground wire and a beefier bed attachment to the bed.

Purchased and then after messaging about this print bed, I let the seller know that the bed would start heating immediately. Without the dial controls on the cr10 menu. The heated bed would not respond to any of my inputs to set temp, reduce temp, or anything. It would just continue to heat and heat and never stop. I finally after a few restarts, and some trouble shooting, even checking the printer's mosfet component that the bed runs off of, came to the realization that this heated bed didn't function properly.The printer could not control this newly purchased print bed. The bed would not respond to the inputs. It tried to heat to max, and never stop.Connection is with a molex plug and is idiot proof. There's only one way to plug it in. Impossible to plug in wrong. I messaged about this problem, their response was, "make sure your wiring is correct and check your wires"It's a freaking molex plug!! You can't wire it wrong.Wasn't happy with the purchase and returned. Best part was a speedy delivery......too bad it didn't work.