2Pcs Thin Film Pressure Sensor 20g-2Kg DF9-16 High Precise Force Sensitive Resistor Force Sensor Pressure Sensor Type Thin Film Pressure Sensor Force Sensing Resistor

The media could not be loaded. This combination works great. These little sensors are very fast and they vary resistance well with light touch, medium touch, full pressure. It’s easy to fine tune with Arduino IDE programming. And the Robot Hand is fast (connected to 6v) and very responsive.Pressure Sensor: Scotch taped these pressure sensors to a hard surface then connected to a voltage bridge using 10K Ohm resistors on an ESP32. Wires: sensors connect well to the female end of standard breadboard jumpers. Search “RandomNerd ESP32 ADC” for programming.Two arduino commands that are very helpful converting the analog signal from sensors to the PWM signal needed for servos are: map(); and constraint();Robot Hand: Search “RandomNerd ESP32 Servo” for programming instructions. The library referenced - “Sketch > Include Library > Manage Libraries…ServoESP32” controls multiple servos and is very simple to use

Got them for playing around with a PI. Works fine. No clue about longevity

I tested these for awhile and they did seem to sense correctly. But the leads were really short and it was hard to solder in place. They are pretty flimsy and are really easy to break accidentally.

This was the perfect range for my project.

Excellent

Soldered it nicely and it gave no connection, the other one fell apart, lol.

I use these to build a high-hat controller for my digital drumset. One was broken internally upon arrival (or right after I took it out of the package). The second one works pretty well for how I've set it up.

The sensors were smaller than expected.