CONCORD 6" Diameter High Pressure Banjo Jr Burner Head with Brass Orifice and Build in Stand (Burner Head with Regulator Hose)

Used it this past thanksgiving for a homemade turkey fryer. I welded up a stand, put this under it on bricks and set a large stock pot on it with 4 gals of oil and of course a candy thermometer. Worked great for my first try at turkey frying (breast only in my smallish pot). After the turkey I fried sweet tater fries, breaded green tomatoes, green beans and apple hand-pies for desert. 100% fried thanksgiving! This thing has the capacity to put out alot of BTU's so it was a breeze to control the heat plus it was easy to crank it up to get it back up to temperature fast after putting in the cold turkey. The ring itself is a heavy-duty cast part and it has threaded feet in the bottom if you want to mount it more permanently.

Using this with the Barebones all in one and it works great. Very large heating surface with easy control of the flame. Highly recommend for a burner. Will also use this with my 18" cast iron.

Good quality

went together easily and glad their was an adjustable regulator to get the right flame which is a little tricky. Would of been nice to have a shutoff for the burner so you don't have to use the propane tank valve as a shutoff every time especially when it back fires.Main problem i have is it often "backfires" and the flame is right at the air adjustment opening. Don't think this is a safety problem but do have to shutoff the propane tank valve, let it go out, than try another start. When running with the flame actually on the burner, it works well, is fully adjustable between a carbonizing to a highly oxygenated flame when using Propane.

Decided to try this to replace the rusted out burner in my Smokey Mountain smoker. I improvised a bracket to hold the burner and got the smoker working again. This burner holds a constant temperature much better than the smoker did when new. No problem holding 225 F. Adjusts down to a very small flame and up to way too high for a smoker. The original burner was bad about blowing out with light wind gusts. Wind will still blow out this one since I'm using a fairly low flame, but it happens much less often. It's a big improvement over the original.

Replaced my burner in my outdoor cooker used for canning. Works great. Has a flame adjustment for intake air.

I bought this for camping and traveling when my camp chef stove is too much, but a little Coleman camp stove is not enough. Deep frying, for example. I just use three bricks to keep my pan elevated, while the burner sits on the table. It’s much cheaper and smaller than a dedicated frying unit. The regulator has a valve for fine tuning your flame.

Worked pretty good lights up well and nice heavy duty feel