Draw-Tite75579 Class 3 Trailer Hitch, 2 Inch Square Receiver, Compatible with Chrysler Town & Country, Dodge Grand Caravan, RAM C/V and Volkswagen Routan (please verify VEHICLE APPLICTION)

The media could not be loaded. Easy to install and fitted literally perfect. I used a Dewalt 20v impact to take out the bolts and to reinstall them. If you use a regular wrench, it will take you a while to do the install. (Careful with your wrists). The driver side was very easy to remove the bolts and to reinstall them. The passenger side however has a muffler and you will need to remove two muffler bolts hangers in two different locations, so that way muffler can nudge to the side a little bit to get to the bolts. I suggest you do the muffler side first so that way you can put the hitch onto the muffler (you have to angle the hitch in) so the muffler can hold the hitch in place with no bolts. Then you raise the driver side and insert the bolts finger tighten. Next you go to the passenger side and start to put the bolts on there as well. Once all the bolts are in place then you can tighten the hitch bolts in. Once all the hitch bolt are secured reinstall the muffler bolts back in. I also used my ramps to raise the back of the van which helped insert the passenger side through the muffler. It is heavy so ask for help if you need it. Took me less than 30 min.

Product is great quality is fantastic. The UPS driver struggled with this awkwardly shaped heavy object for delivery.Couple suggestions before you buy this. Get a 2-3ft breaker bar from harbor freight it will make your life easy. I could not have done this without this since the bolts on my 2015 chrysler T&C were rusted over.Rhino ramps and wheel chocks made this super easy to install along with an extra set of hands. I'm overally cautious so i also used jack stands. Overall took maybe 30 minutes from start to finish to install. I also useRemove 7 total bolts. Put on hitch. Then put the 7 bolts back. Hitch is just heavy and awkward. I used a floor jack/jack stands to help position the hitch for install.

Easy enough to install (moving the exhaust was annoying but part of that process). Appears to be very sturdy and fits great. I used a cargo hauler with about 400lbs on it for 800 miles. I had zero issues with the hitch and happy to finally have one installed!Biggest recommendation is to make sure you have the right tools. I had to purchase a breaker bar wrench as it was not possible to remove existing bolts without it.Very satisfied!

installed right in on my town and country

It fit with the help of a prybar. I think drawtight needs to check their specs. If you get one side in and leave the screws kinda loose you can bend the other side till the holes line up.

Fit my 2014 town and country perfectly no issues easy install

If it weren’t for getting the bolts out of the van very easy to install. It took about 2 hours to install by myself.

This hitch, despite what some of the other reviews state, is an easy to bolt on hitch that required no special skills to install. It does NOT come with hardware, which some reviewers complained about but it does not NEED any since the hitch utilizes existing bolts/hardware. The instructions are well laid out and easy to understand if you actually need them (I did not). One note to ease installation. The muffler needs to be unbolted from it's hanger, which is easy enough however despite that the fact that muffler is unbolted, the operating room above it to access a mounting bolt is quite small. Unbolting will require the necessary socket but also realistically requires a universal joint attached at the point of the socket with a 6 inch extension. To make the job easier, since there is no swing room for a wrench, an impact gun with a universal joint will make life far easier for this install, specifically for the bolt above the muffler (that's what i used) but it's not mandatory. Also, this hitch is compatible with "stow and go" seating, which is on my van (2012 dodge grand caravan). This is a two man install only because it's quite heavy and wide. A floor jack will suffice if you don't have a second set of hands to hold the hitch up as you perform the install. Just figured I would offer my two cents.