CRJ 24-Pin ATX Power Supply Jumper Bridge Tool

Sizing of interconnection is no problem with this jumper. I just hope I can find it the next time I need it. Works perfectly.

Used this to fire up the cooling system on my computer, to get the air out, without having to power up the whole computer.These are easy to make but for the price It was easier just to buy this.

Simple solutions are the best solutions. I am using this to power multiple Corsair, Seasonic, and be quiet! PSU's for various use cases ranging from powering a fan stack exhausting dust generated by my CNC and laser-cutter to fans used in a custom-built Mac Mini mini-rack.Typical exhaust fans are extremely loud, so instead of standard options, I opted to create a fan stack using Noctua and be quiet 120-140mm fans. Using a SATA-powered PWM hub, this connector allows me to keep the hub online and the fans running at full speed during operation of the CNC and laser-cutter.For the custom-built Mac Mini mini-rack, this allows me to run an SFX PSU within the chassis of the rack and draw intake to the base of the Mac Mini, driving exhaust through the backplate at a faster rate.

Tricks the ATX 3.0 power supply to be always on. Use case is powering external GPUs for training on a Dell R630 U1 server. GPUs are in a rig attached to the server via a 600mm GPU riser cable (ASIN B0C415XBQZ). Works well.

You can use a paper clip, but why take the chance of damaging the pins. Handy to have if you work on computer psu

Great price and good product. Was cheaper then the local store

You buy one of these when you want to test a PC power supply and turn it on without a motherboard.All it does is shorting (maybe with a resistor) 2 pins.This works without any problem.I would have given more stars if the short was "internal" and not external like on the photo and ready to be pulled off by mistake.Also DO CHECK if your new power supply comes with one already. Mine did, I just didn't check ;-)In case that helps someone, if you have an AsRock motherboard that does not power up the power supply, it's likely not the power supply, but the coin cell battery on the motherboard that is dead. Fancy server motherboards apparently are not happy with dead cell batteries...

I was looking for a jumper for my power supply unit (PSU) that I had purchased. Unfortunately, the PSU that I purchased didn't include a jumper bridge connector. I needed one to get my PSU to power on and run. Fortunately, I found this jumper bridge connector. It works great! I ended up buying another one for another PSU that I bought. Recommended if you're looking for 24-pin jumper bridge connector to get your ATX power supply unit to power on and run.