Key Fob Keyless Entry Remote fits 1998 1999 2000 2001 2002 2003 2004 Toyota Avalon (HYQ12BBX w/Panic), Set of 2

Pretty straight forward instructions but it took me a few times to get it right. The step that asks to press both the lock and unlock buttons at the same time.. The car will not provide any feedback until you press lock just after pressing both. I kept hitting both over and over again expecting something to happen and that's what took me several attempts.

Fobs worked great once you found the correct website using a search engine. . .The quick start guide that came with these fobs pointed to a site that required you to pay to view programming instructions??? What??!! I tried a few times and kept getting weird sites. I just Googled the instruction online and both fobs programmed correctly once I read the mistake I was making during the 4,327 steps needed. Just kidding on the step number but pay close attention. Worth every penny!

As others have mentioned. This does not work on a 1998 Avalon. I go through the sequence and it always ends in 2 lock cycles indicative of failure to connect. Oddly, it would occasionally lock the doors, a couple time it unlocked the door, once i got a trunk pop, even a lock for an unlock button. Maybe the quality control is not good and they just didn't work right. In any event I'd pass on these at least for 1998 Avalon.

They work really well

Arrived on time. Had both units programmed with in 15 mins. Works Great. Thank you!

Didn’t work for my car

After 5 years of using this after market remote, it finally died. I repurchased & for the money you can't beat it for a car that is 21 years old! Granted the programming instructions online are a little confusing by the manufacturer, but if you "YouTube" the instructions, watch & listen closely, the remotes should sync! It did take me 3 tries to get it, but hey I'm old...lol

I have a 2000 Avalon xls. with the V6, and with a tutorial I looked up online I could easily pair the remote to my car.here is the way to do it.unlock and close all the car doors.open the driver side door.put in the key then once you hear the key in ignition ding remove the key, do this very quickly,then cycle the door locks 5 times, by that I mean lock then unlock the doors with the button 5 times.close the drivers dooropen the driver doorcycle the locks 5 more timesinsert the key and turn the ignition to the run position, then back off and pull out the keythe door locks should cycle on their own at this pointonce you see that the car is in programming mode and you can program the fob.press the lock and unlock buttons on the fob you want to program at the same time. then immediately hold down the lock button for about 3 seconds.the door locks should cycle again and the remote should be paired.close the door and then test the remote to make sure it is paired.if it didn't work look up a video and be sure that you followed the steps correctly.