Blisstime 2 Sets 4pcs 6 String Acoustic Guitar Bone Bridge Saddle and Nut Made of Real Bone

Very stable dense bone.

Great

I installed it on my acoustic guitar. As I needed a new one, my strings were sinking. I fixed and build my own guitars.

Bought these for my Yamaha FG800. The nut needed minimum adjustment for height, more to adjust the width to fit in the slot. If you need to adjust the width, sand down the flat side that faces towards the bridge so you don’t change the break angle of the strings going into the notches cut in the top of the nut. The length of the nut was perfect.The saddle was a little short on length, but that was inconsequential as you can center the saddle in the bridge slot to line up with the strings being in the correct spot for the compensated saddle. The width was perfect drop in to fit the saddle slot. As usual, the most adjustment was needed for the height which is common on all saddles. Best to use a coarse grit sand paper to start, then move to a finer grit as you get close to your desired height. I use 150, 800, respectively.The Yamaha FG800 is my beat around acoustic so I had never wanted to spend the time to upgrade the nut, saddle and bridge pins. After buying Blisstime bridge pins for my more expensive acoustics, I was so pleased with the quality and cost, I decided to upgrade my Yamaha with Blisstime bone nut and saddle, I already had bone bridge pins laying around. And oh man am I glad I did. The tone and sustain on my Yamaha is so pure now, I love it.

works as it should

Everything was good quality and shipping was quick.

Had to shave down the nut with sandpaper to fit the spot in a Gretsch Jim Dandy, but it only took about 10 minutes and it fit right in.The bridge just needed a couple hard swipes with sandpaper to be the same height as original.Great value, noticable difference.

I've only just installed the bridge saddle, I haven't yet installed the nut, so my rating is for only the bridge saddle.I have an inexpensive chinese-made acoustic, (Kona), which is a surprisingly good guitar for the price, in terms of materials, fit, and finish. The tone was also okay, when played acoustically. It also has a piezo bridge saddle pickup, which, unfortunately, sounded awful. The loudness of the E and B treble strings completely swamped out the other strings; the guitar was unplayable "plugged in". In a rare instance of it turning out to be good luck that a part on a guitar failed, the G string split/crushed the weak plastic saddle, so I replaced it with this bone saddle.In terms of dimensions, the replacement saddle was almost perfect. Replacement task was relatively easy, I only had to carefully file some string notches and sand about .020" off the bottom of the new saddle. The improvement in acoustic sound was noticeable, but not drastic. I would call it more balanced, also a little less bright. But the improvement in sound when listening to it plugged in was yuuge. The loudness balance among the strings is almost perfect.It didn't turn my $120 guitar into a $1200 guitar, but now it's playable plugged in, and I consider the bridge alone worth the cost of this Amazon item, because it so profoundly improved the piezo sound.I did a side-by-side dimensions comparison of the new bone nut with the one on my guitar, and it seems almost a perfect twin, but since I haven't yet installed it, I have only one other comment on the nut. Considering how much better the guitar sounds with the bone bridge saddle installed, I suspect the nut will improve the sound an imperceptible amount, (on chords with open strings only). Keep in mind that depending on your guitar, changing the nut can be risky, because it may be difficult to change it without damaging the guitar's finish. That is why I deferred installing the nut, I'm just not compelled to at this time. But if the nut on the guitar is ever damaged, I now have a spare.