OTC 7393 Gear and Pulley Puller with 5-1/2" Long Forcing Screw

Bought this to help get a stuck flange off a 2008 Volvo XC70 and it worked perfect for pulling the flange off using two spare boltsJust an added tip: For reinstalling the flange, and loosening the center nut, a Volvo 999-5433 (CTA Tool equiv. CTA-7635) counter-hold (used for other Volvos to install the harmonic dampener) works like a charm

This gear puller was just what I needed to pull the flywheel off the Briggs & Stratton engine on my Craftsman lawn tractor. The only other things that I needed to get it to work were 4 flat washers, 2 longer bolts and 2 nuts. Worked like a champ plus I can use it for pulling gears and pulleys.

I very like how it's built

Gear puller worked as advertised but could use grade 8 bolts. I bent the ones it came with

acero inoxidable puro excelente 👌 👍 😎 ✅ 👏 ✔ 👌

This wheel-puller tool is very rugged. I beat the snot out of it with an impact wrench to remove a rear wheel from my lawn tractor. I used threaded rod instead of the bolts it came with because they weren't long enough for my particular wheel. I highly recommend this tool. However, I also highly recommend buying the wider model if you want to pull lawn tractor wheels. The one I bought was almost too narrow, whereas the threaded rods where right at the ends of the tool.

Tried Several Different types of Pullers to get my Flywheel off my Riding Mower, it was a tough one! I am a Small Engine Mechanic and pull flywheels all the time, but this one was tough! Got this Puller off Amazon, received it very quickly. Set it up, most easy puller to set up, pulled my flywheel off with ease. All my other pullers are going in the trash, this one rocks!!!!! Plus it takes up less room in my tool box on my mobile service truck. Great Buy!!!

great company, great puller but find the right bolt thread patterns at the hardware store.this puller came in handy but the bolts provided did not work for my need, I went to my local hardware store and got some bolts that have the same thread pitch as my driveshaft yoke as well as some washers. it took very little force to remove and an hour later my truck was back on the road.dont forget to oil or grease up your forcing screw to give you much more ease.