10Ft Weatherproof Universal Garage Door Bottom Threshold Seal Strip DIY Weather Stripping Replacement，Not Include Sealant/Adhesive (Black)

Absolutely blown away by the quality of this threshold moulding . Highly recommend.

Works so nice

Not advertise length 16 feet 4 inches not 16.5 feet. This will not make a difference in my application, but for anyone ordering and needing the full length they will be disappointed. I ordered 3 for our barn overhead door thresholds and all three were 2 inches short of advertised.

Holds up over time and keeps the water out of my garage.

We asphalted on our previously grass driveway, which completely changed our drainage pattern. I ordered these hoping it would guide the runoff to our drain, and it has, and it has VERY WELL. We'll be using these until we can add a better drainage system.Note: As instructed, we did not yet glue them down because we knew this was a short-term fix. Even in the torrential rains, they haven't budged. These work is way better than I could have imagined.I only wish these came in longer strips.

I hope it works as it's been too hot to fully make the time to install it.

Placed under my garage door…came with easy to install directions…seems to help keep out pests. I would recommend to anyone…

I loved the idea of this strip to seal the bottom of our garage door. The floor is a 50 year-old slab and had significant evidence of wear (loss of concrete) in one area causing a 1" dip in that area. Dry-fitting this strip there was still an open gap, so I leveled the area with self-leveling mortar. The result was much better and eliminated the space, but the strip of floor was still not perfect. And there is the problem -- unless the floor is perfectly flat, there will likely be installation issues. For me, the result was a terrible time gluing down all of the front/back edges, which would lift up wherever there was the slightest defect in the floor. Liquid Nails (recommended) did not stick well, and I had to weigh down the edges with weight to flatten them, and even tried a heat gun. The result is mediocre -- the seal with the door is fine, but the edges are not clean. Days later, I am still working on small spots where the edge has lifted. Overall, a pain to install and I cannot recommend unless you have the perfect installation situation.