911 motorsports Circle Cutter Guide - 5 pc. Kit - .380"

Let me start off by saying that I am relatively new to plasma cutting and what little experience I had has since been forgotten. I haven't used a plasma cutter in several years until I recently purchased a new Hypertherm Unit. I only made a couple of practice cuts to get a feel for the drag tip and started using the stencils right away.These plasma cutting stencils were exactly what I needed and look forward to finding more uses for them! I think they are well worth the price for the quality of cuts I was able to achieve with them.I mainly bought this set originally for the 1/2" stencil alone but have since found several other uses for the other sizes. These stencils allowed me to finish up my welding table project by cutting 1/2" bolt holes for mounting my vice and by using the outside radius of the largest stencil to round my welding table top corners. I am using a Hypertherm 30 XP with a drag tip to make the cuts and couldn't be happier with the end result.

Casey ladell is never wrong

These are a must have if you are doing anything free had with a plasma cutter. Good quality.

Made cutting holes in hard metal much easier. No more drilling with oversized bits.

These stencils are exactly what I needed for my plasma cutter. I have a HyperTherm cutter and use the tip that allows me to rest the torch right on the surface to be cut. Using these stencils makes for a perfect circle. (The edge is also helpful for use as a straightedge.) I needed to make a larger circle than the largest stencil, so I traced the outside of the stencil with the torch. The end product resulted in a circle that was two inches larger than the circle in the center of the stencil.

These work well for steel hanging targets and do make attachment easier.

They work great easy to use the laser indexing marks make layout easy buy them you will like them too

Seem well made