3mirrors Front Differential Support Bracket Mount Frame Brace Axle Bushing Bush Compatible with Hummer 2006 2007 2008 2009 2010 H3 H3T 15773961 25872770

Exact replacement for OE front differential rear bushing that has probably already failed in your H3. Hear a clunk when you accelerate from a stop, or shift from park to reverse? It's probably this bushing.Getting the old bushing out is a bit of a chore, but there are several ways to do it depending on whats in your toolbox. I ended up using a 5lb sledge and a chisel to collapse the old bushing and pop it out, but a sawzall or press or air hammer would all work too. Once the old one is out just clean up the hole in the crossmember, put a little grease on the outside of the new bushing, and use a ball joint or hydraulic press to press it into the crossmember. I stacked up a half dozen washers to fill the gap between the inner and outer sleeve flanges right where the cutouts are before pressing the bushing into the crossmember. This keeps the rubber of the bushing from taking the full force from the press. Worked like a charm, no damage to the flanges or the rubber and the bushing pressed in flush.

Fits my car

Fit perfect, installed easy, worked perfect , good quality.

This worked perfectly to replace the worn out carrier bushing on my 08 H3 Hummer Alpha. I took the bushing to the shop with my vehicle. They removed the cross member, pressed the old bushing out, pressed the new one in, and reinstalled the cross member in less than an hour.

This is a great way not to have to replace the whole bracket for way more money.

Pressed the old one out and pressed this one in no problem. Way better than over paying for some poly junk or having to buy a whole new cross member from GM.

My local mechanic tried to get me to buy the part through him at a discount. But this was still less expensive and worked perfectly fine. I would definitely recommend apart. I bought it for my 2007 Hummer H3.

Heck of a lot better than replacing the entire brace. Quick work with a press.