Rockler422866 Router Table Box/Finger Joint Jig 1/4 inch / 3/8 inch / 1/2 inch (422866)

Great results with this jig, straight out of the box. Works really well, good easy to understand instructions. Just make sure you do not use cheap router bits.

It's everything I expected it to be. Not sure how long the t-slot track will remain sturdy being mounted into MDF. For the price I would have expected it to have an aluminium base - but hey - I knew what I was buying.I see a question regarding will it fit on Lumberjack RS1500 - yes it will - though you need to borrow some parts off the front feather board that slot into the narrower t-track and all is then good and solid. Bit of a learning curve - of which i'm only part way through but initial cuts look promising. Deffo get an upcut spiral end bit for this - straight cut just tears everything out. So as it was a treat - I'm reasonably happy - but I could have made it myself for far less

I'm making a cabinet makers wall mounted tool chest, and needed this to join the corners, it workedwonderfully, Thanks

well made quality product

Needs the option of a metric set upAnd no use at all for anything large like a drawer side as it rocks in the railsShame it wasn’t made with t tracksBut for small stuff it’s cock on and very handy

Had a problem where the bars of 5 star restraining knobs did not fit into track. However, by using my feather board bolts from same track it worked perfectly (thank you other Amazon user that suggested it). Once everything in place. Off you go. Brilliant piece of kit. Very happy and easy to use.

When I came to use this jig - after a lot of research as to the one I wanted to get - I discovered two problems.First, the European marketed box came with an instruction leaflet which described the spaced bars in metric (mm). None of these measurements corresponded exactly with the spacer bars in the box, which were marked with imperial measurements. The only way to try it our, I suppose, was by trial and error????Second, the 1/4 inch spacer was approximately 0.1mm small than 1/4 inch, making it impossible to cut a tight fitting joint. A review on the Rocker website also details this.A pity this inaccuracy was present on what seemed like a good bit of kit at a good price.Rockler - I think you need to look into this!!!!! Are you metric or imperial?

I had read a review and an answered question that said this Rockler Box-Joint Jig did not fit the Trend Router Table, but it does. To be clear I have the Trend Workshop Router Table and it fits perfectly. With a bit of care, it cuts cleanly and accurately. There is however a smaller Trend CraftPro Router Table, which I cannot speak for. My old one was a thrown-together shop-made jig, which was fine, but I dropped metal vice on it.