5-Pack RocketBus Small Fine Edging Tinting Vinyl Installation Hand Held Applicator Rubber Squeegee for Car Auto Tint Glass Film Bubble Remover Remove

Absolutely perfect for use on a resin 3d printer to clean the FEP film or mix the resin in the tank. Doesn't seem to scratch it at all and is flexible but firm enough to fit in the corners. Very much recommended

If you're reading this because someone recommended these for your printer, just go ahead and buy these. They'll work marvelously for you.I bought these on a recommendation to use for squeegeeing resin off the FEP film in my SLA printer's resin vat. Have to say, I'm impressed! These work great for that purpose, they also work great for stirring up the resin between prints, and they clean up great! No small feat for tools being dunked in photoreactive resin on a regular basis.I'm going to be actively recommending these to everyone I know with an SLA printer.

This squeegee is thinner and more flexible than the ones used for autobody work. It's best used for applying window tint film, decals on bikes, or glass protectors for IPads, IPhones, or camera screens. What's nice is it has three different edges you can use of different widths in the same squeegee.I am mainly using these for smoothing out caulk or spackling applied to nail head holes on carpentry applications. They will also work when applying glazing putty during autobody work and is a bit more flexible than the usual black, rectangular ones sold for that purpose.

Good product, works fine.

Great Quality good value.Perfect product to squeggie the resin off your SLA 3D printer FET. . Flexable and sturdy and will not scratch the clear membrain.

I purchased this product on the recommendation of some fellow 3d printer enthusiasts to use during the cleaning of a resin printer's vat. Much like pushing the bubbles out of a vinyl, this device easily pushes resin along the surface of the FEP film without damaging the film or leaving residue behind. An absolute must for resin printer clean-up, this device works even better than I'd hoped.

Works great for squeegee-ing the FEP/nFEP bottom of a resin 3D printer without scratching the film (on a printer by Anycubic, Elegoo, or EPAX to name a few). Some of the squeegees required removal of some flashing, but with scissors that wasn't a big issue. The material is more of a rubber than a silicone, but for my purposes it doesn't matter, and far more effective than using the included hard plastic scraper that came with the printer with a lower risk of damaging the FEP/nFEP film. There are enough in this pack that I'll probably use one or two with window tint films when needed.

When your using an expensive resin you want to return every drop possible to the bottle and these are the perfect squeegee for the job.