Arduino Nano Microcontroller Development Card for Robotics and Electronics + USB Cable

The only reason I gave it 4 stars, there is no documentation that instructs you to use the select the Processor as the ATmega328P (old Processor). You must use this or the L led on the NANO will flash and you will not be able to upload to it. A little bit of a headache if you're not aware

Ordered these (acknowledging you get what you pay for) for some miscellaneous projects. Used a Vin of 7 volts to power them on a project board (from a good PS with no known voltage spike tendencies). First one blew the on-board voltage regulator right away and funneled 7 volts to the 5v output and about took out some peripherals. The second one ran for a bit but finally succumbed to the same flaw as the first (actually puffed some smoke this time) but the main chip got very hot (?). The third is still hanging in there and running fine. I suggest looking elsewhere.

I use the Arduino IDE (v. 1.8.1) for these boards. To get the compiled sketch to upload correctly, I selected the "Arduino Nano" board, and had to select "ATmega328P (Old Uploader)" for the processor. The processor selection of "ATmega328P" was the default for the IDE, and would not work correctly.Other than that, so far so good.

2 of the 3 I ordered worked. I'm still playing around with them.

I love it!!! Saved me $ by not having to purchase a 18650 battery spot welder. I was able to make one using the Nano and a couple other parts. Will be ordering more for future projects...

Perfect for playing with and have the boot loader installed already but be aware the supplied USB cables are very short...

Item as promised!!!

RoboGets 3 PCS Arduino NanoWould not connect to any computers, tried using Arduino 1.8.1 like someone else suggested and it still wouldn't connect