Raspberry Pi 3 B+ Case, Raspberry Pi Case with Fan Raspberry Pi Heatsink Raspberry Pi Fan for Raspberry Pi 3 B+ & Compatible with Raspberry Pi 3 Model B, Pi 2 Model B, Pi B+ (Black&Clear)

Great little case for the B+. Best looking of any case I've seen.Built well, built correctly, assembles fairly easily, given that it consists of multiple layers. This will be my go-to case from now on.Some tips:1. Look the diagram over before you start to mount the fan. While I managed not to break anything, the wires and connectors are a little delicate, and it takes some planning before you screw the fan into the cover.2. Also, I missed the instruction to install the heat sinks AFTER everything else is put together (but before the top cover with fan is put on, of course). I was lucky, but on my second one (for another Pi project), I did it in the right order and avoided a bit of anxiety.3. Both top and bottom plates have a protective film over the exterior side. Remove that before you put the pieces together.4. I found it easiest to stack the layers and keep them oriented the same way as I was assembling the case around the Pi. This way I didn't have to do any serious analysis about which way each layer went.

I don't often write reviews but for this one I just had to do it! I saw a video review of the case not too long ago and when I came across a mount for my 3d printer on Thingiverse I decided to go for it and buy it. I am glad I did. I was not sure about it being made of multiple layers but it was very easy to assemble and the direction were very clear on the steps to assemble it. I like the fact that I can wire the fan at either 3.5v or 5v and it looks great!! It comes with 3 heat sinks (quite a few out there only come with 2 but this includes a third for the chip on the bottom). It is very sturdy and has access to all the ports. If you are looking for a great case for your Raspberry Pi then I highly recommend this case.

The fan is pretty loud for its size on high. Low speed is quieter.Pi 3b went from 40c to 31c. with low fan. 25c with high fan.Kind of a pain to assemble but it's not too bad.An all metal case might have been better for cooling but for the price this is good.

Clocked from 600 to 1400 and running cooler than stock.

Goog quality case, and great customer support!

Item came clearly used. Dissatisfied

Nice case for the raspberry pi. The instructions are clear and complete. There is a protective plastic on the outer pieces that need to be removed before you reassemble the case. I like that, you have a clean and clear case when you start. The fan that is included is nice if you plan on using it on a project that runs 24/7 and the heat sinks. The price is right for everything you get.