FLASHFORGE 3D Printer Resin, LCD UV-Fast-Curing Resin 405nm Standard Photopolymer Resin for LCD 3D Printing with High Precision Printing, Low Odor (Mecha Grey, 1000G)

I really just bought the most affordable resin at the time for my 9k printer. I wasn’t expecting much, but this resin printed in very high quality. I printed some models and lithos and they all turned out great

Cure and exposure times were increased by 50 percent. By the time I got this crap product dialed in, I didn't have enough to build part. Now I am buying the brand I should have. Not recommended at all!

Nice color and doesn’t smell quite as strongly as the Anycubic green resin I had before. I printed tiny solid bottles, so don’t really now how brittle this is, comparatively.

i like to test different print settings and various cheaper priced resins. it doesnt come with any suggested settings so i tossed my goto 3/30 exposure setup at it in both my saturn and e10 machines. i left the machines running over night both on 8hr builds and when i came down i was pretty pleased.my saturn is usually bit hairy/stringy but good lines and details. the same level of detail was there and not really any hairs to notice. the supports where nice the surfaces not to layered looking, it was a solid general purpose print.my e10 is a diva she only really does well with epax gp resin for some reason, but the end result was not bad. the supports seemed harder and contact was deeper than my normal prints, which surprised me. just means more clean up after the cure and not as clean a surface, would have to adjust the settings for this resin in my e10 i suspect.overall solid cheaply priced resin, low smell good detail and no failures in 1k bottle and full build plate prints.

This is by far the best quality and value for clear resin that I have found on Amazon. Low odor and low priced combined together with great prints is really a great find.