ANYCUBIC Kobra 2 Hotend 3D Printer Extruder V5 J-Head Print Head with Silicone Sock 0.4mm Nozzle 24V Ceramic Cartridge Heater ONLY for Kobra 2,Kobra 2 Plus,Kobra 2 Max,Kobra 2 Pro,Kobra 2 Neo

The media could not be loaded. I needed a replacement hotend, this was affordable, fast delivery and an easy fit. I also got the covers, very satisfied and printing well.

Very quick delivery, excellent price, perfect fit and working well.Very easy to fit to the head unit and after many hours of printing still perfect. Very pleased.

The media could not be loaded. I am deviated, I have replaced my hotend many times before but after replacing it with this product my 3d printer started to steam up rapidly, the faulty hotend caused the side of the printhead to melt and now my 3d printer is unusable, I have contacted the manufacturers about this issue to rule out the possibility of anything else that could have caused this issue and the manufacturers said it was the result of the faulty hotend that I purchased, this was a terrifying experience to have to go through, I have now lost my 3d printer which I spent so much money on, I am just glad that I was there to ensure that the new hotend was running properly as I managed to notice the smoke in time and was able to turn it off in time. If you care about your safety then do not buy this

Nozzle/ Tip was over tight and snapped 1st change Good quality just costly keep replacing as this is the 2nd one I’ve had to replace(The other 1 being from another company and was really loose and leaked ruining all my prints)

The media could not be loaded. I needed a new hotend for my Chiron and I am so glad I went for this one. It comes with everything you need and can be fitted in less than 10 minutes. The Ptfe tube is plenty long enough although I have kept it back due to having a capricorn tube. All I had to do was a quick bed level just in case there was any difference in height and then I set it off on this 9 hour print. This is a very good alternative and for the price it's even better. It was all nice and tight when it arrived and the leads were the perfect length to connect straight to the circuit board within the hot end shroud. If you are asking should you trust this hotend, then please look at my video for the quality this gives.

Bought this as mine had given up, arrived quickly, fitted in around 10-15 mins, minimal bed leveling, i would say this is the first head that has given me the best prints to date the layers are spot on and with a bit of tweaking with the temp no stringing. excellent results, if the results are not good with this head then its probably poor filament as i found out through trial and error. Great Value.

Having fitted, I always heat up and check tightness of nozzle in heat block before use...These were fine

Bought this after I snapped my nozzle trying to clear a blockage. The block also broke my PTFE tube to needed a new one of those too.This arrived and was a like for like for the original. Swapped out no problem and was printing straight away. Tested it by heating it to 240c which it did in probably a minute (I didn’t time it but it was very quick). Very happy with the print quality, as good as the factory part if not better.Only criticism is that the PTFE tube should be longer. It is shorter than the factory tube. It’s not long enough to clip to the wiring harness as it only just reaches when the X axis is at 0, with some harsh angles that might restrict the filament. Whilst I don’t plan to print to the extremes of my bed very often, if you are, you might not want to rely on that tube.Overall, a good purchase and happy with the price