Gutter Downspout Extensions,Catch Basin Low Profile Downspout Extender,Extendable from 1.34’ to 5.1’(White Basin Kit)

good deal

Looks sturdy and flexible enoughTime will tell

We've got a bit of a drainage issue in the yard. Until we can get the landscaping done these have been helping a lot. They dump the water from the gutters far enough in the yard that it is no longer running back to the crawlspace. They were easy to install, I actually did it all myself in under 20 minutes for 8 down spouts. The hardest part was getting them all stretched out, after that installation was a breeze.

Easy to install and fits really well. Plastic is slightly flimsy. It seems sturdy enough upon install but seems like it'll degrade quickly in the sunlight.

What you get in the box is 2 flexible plastic tubes. With each tube comes: (1) a 3"x4" connector piece which in my case was already screwed into the tube, (2) a 2"x3" connector piece to screw into the other end of the tube, (3) 4 screws that easily pierce the plastic connector and also a metal downspout so it attaches the connector to the downspout.To install:(1) extend the flexible tube to its full length(2) screw on connector pieces - important to screw the connector into the INSIDE of the flexible tube not the OUTSIDE as I initially tried(3) disconnect any existing angle piece from your downspout so you can connect directly to the downspout. I used a hammer and chisel to knock off the existing metal one(4) determine if your downspout fits the larger or smaller connector - in my case it was the smaller connector(5) connect the appropriate connector to your downspout and fasten with up to 4 screws - I used two in the front and 1 on each side (can't reach the back)(6) repeat the same procedure with the 2nd tube/connector/screws

Thin material

This is just what I needed maybe a little short but it does the the job well easy to install

These are inexpensive and super easy to attach to your existing gutters.