Stack multiple plates, breakouts etc onto your Raspberry Pi with this custom-made extra-tall and extra-long 2x20 female header. The female header part has extra spaces to make it 13.6mm tall: when placed on your Pi, a PCB will clear the Ethernet and USB jacks. The stacky pin part is also extra-long, 9.7mm, so that when a standard 1.5mm thickness PCB is installed, there will be 8mm remaining, plenty to plug into.
K**N
Works as intended - requires soldering!
Even though this is advertised as a push header, it does require soldering for a proper gpio pinout connection.Otherwise works as intended, no problems once soldered.
D**N
Great if using a RGB-PI or PI2RGB
You need this if you are using a PI2RGB or RGB-PI and have a case which doesn't expose the pins.Works a treat.
G**H
Bad product description, does not mention the fact you cannot remove the 2 included spacers.
After spending an hour of my life trying to remove the 2 black spacers (as I needed the extra length on the pins to pass through the socket on my ModMyPi relay board) I've finally concluded they simply cannot be removed. Really disappointed as the product description does not mention this fact. Funnily enough, if you browse to the same product on the ModMyPi website, they state there the shrouds/spacers cannot be removed. A shame they didn't include that vital detail on the amazon product page! Now I have a destroyed header, sore fingers and some ££ down the toilet.
A**R
Four Stars
Does the job well
R**H
Great to raise up a HAT on the Pi
Used this to add some space between a HAT and the Raspberry Pi (adding extra plastic spacers to the HAT to support it).Pushed the Tall Header onto the Pi, then pushed the HAT down onto the Tall Header.
D**A
this is not acupuncture
Used this to extend my pins on my pi so I could fit my dac over my heat sink and fans.Worked.
T**H
Five Stars
Arrived as advertised exalant
I**N
Very useful connector
Useful for stacking Pi hats
Trustpilot
1 month ago
2 weeks ago
