Sticker Connection | Fender Stripes Hash Marks - Vinyl Decal Universal for Car Truck Sticker Racing Stripe (Yellow)

Squeegee is a must! (I used a card, worked fine). The appearance is nice, I had a few bubbles, the one shown is the one I couldn’t get off but the other is fine! Set the sticker down first and then peel! While you peel squeegee as you go and it’ll give a smoother look. I used a heat gun to seal but idk if it’s really necessary

These vinyl stripes are great and went on smooth! I'm not entire sure why someone said they're "not auto grade vinyl" because when they're on, they are definitely on. This was my first time putting vinyl on and it went great! I definitely recommend spraying the area down with soapy water so you can move it around until you start to squeegee it. A hair dryer also works wonders to get it to adhere faster. You can try the dry method if you're super confident in your abilities but spraying before hand made it super easy. Also, take your time. I almost screwed everything up because I thought I had to do everything quick.

This was a great little spice up for my M235i. I’m definitely a “brand snob”, so since this was not made by BMW I didn’t really know what to expect. My expectations were met! I read a review that someone else posted and they emphasized to take your time. I would agree 100%. I have built racing engines and tooled on dozens if not hundreds of cars over the years but I am NOT a body work person or do I claim to be, but I am a perfectionist so that helps! I had a couple of small bubbles I thought I might not be able to get out but with a heat gun on low and something to make a pin hole in the decal everything laid down nice and flat. Good product, would purchase other items by this brand in the future.

Came Rolled in tube, let them sit flat under a cutting mat for a week then we were ready to roll. Fill a spray bottle with water and 2 tablespoons of 91% rubbing alcohol and 10 drops of Dawn.. after cleaning the car surface with alcohol, mist the car and the exposed adhesive back and position as you like. Squeegee out the moisture and heat dry it. I trimmed mine down to fit the lines in the hood and side panels. Looks great, super easy install. Only caveat was the glossy finish got marred some from excessive rubbing, which was my fault

A little hard to get the bubbles out. I used soapy water, squeegee and a hair dryer. Overall looks good just take your time.

This product is not worth your time in purchasing, it’s Impossible to get the bubbles out of the material and due to the way it was rolled up it had creases and when you went to work them out the material just made little tears .Needless to say it went in the trash

Not thick enough, might as well just list it as 3 inch black electrical tape.

Used the soapy water method. You can search for a installation video on You Tube. Looks great on my 2012 Mustang. Added 1/4" pinstripes I bought at my local auto parts store for a more custom look. Will try to give a review in a few months to see how they hold up.