3D Printers, Perfectink A10S Aluminum High Precision Dual Z-axis Semi-Assembled 3D Printer Kit with PLA Filament TF Card (Large Print Size 300x300x400mm) (3D Printer)

Fixed my problem with the A8's factory carrier. Stock Carrier threads are so low quality that I stripped out something like 5 of the screws installing and ultimately led to the bed being extremely difficult if not impossible to level. I actually had to stop using one side of the bed because I couldn't adjust. This bad boi is thick and rigid and machined to very tight tolerances. It really is a perfect fit. For those wondering, the bed level screw holes are not tapped - you can look into alternate 2-nut tightening methods, but personally I upgraded to an auto-leveling sensor and just keep the bed on now with screws, springs, and a single wing nut.Only real cons would be that it is slightly heavier and, in my opinion, it could probably stand to be a little cheaper. This is the most expensive modification I've made to my printer, and while I don't regret it, I personally believe it's probably closer to $15-20 upgrade vs. >$25. I would say if you have no issue with your leveling screws stripping out, you don't need this. If leveling your bed is a pain, this will likely help to some extent, but the auto-level sensor would be a cheaper/more effective solution than this alone.In all, I'm very happy I went with this. I just believe the price is a little over-inflated considering what it is.

After installing this carriage plate on my Alunar M508 (Anet A8 copy) 3d printer I no longer have to readjust my bed leveling when changing from pla temperature to BS temps.I did have to readjust the Z limit switch position because of this update and the thickness of the glass I am now using as well.And yes, the price seems a little high to me as well.I am very happy with this plate.

Both of the plates I purchased were flawless and work amazing. I don't have warping issues and rarely need to re-level my bed

Added this to my Anet A8 after I converted to the AM8 with aluminum frame, it came with good packaging and was flat and level.

Great plate, lots stiffer than the old one and holes were Accurate, unlike the holes on the original plate for my ANET A6 which had one hole off center.

Carriage plate was not level / flat which was the reason for purchase.

Fits printer perfectly, very stiff quality material, properly deburred and finished. Solved my bed issues totally, way better than the thin strips that come with the printer.

Exactly what I needed to update my Anet A8. Runs like a champ now and levels easier with 3-point instead 4-point leveling.