Ludex Magazine Speed Loader .22

Used it on my ruger mark 4 lite , it work! (it was loading 9 out of 10 round) Just had to adjust it , which was super easy , now 10/10 rounds loaded

What a huge disappointment. Bought this for use with a brand new Ruger 22/45 Lite. It sorts the ammo as advertised down into the chute. But, everything beyond that is useless. Rounds constantly get stuck under the little ball bearing and need to be pryed out. The 10th round NEVER loads properly, forcing you to always load one additional round manually. But, worst of all... the mechanism for loading requires you to "pump" the magazine in and out over and over. The metal magazine banging against the rounds causes dents and dimples that can cause misfires. Out of the same box of 500 rounds, every box i loaded manually ran 100% clean. No issues! Whereas every box loaded with this piece of junk had at least 1-2 misfires or jams PER magazine. On top of ALL that, it saves ZERO time. By time u shake the ammo down into the chute, pump the mag in and out, deal with rounds getting stuck under the ball bearing, etc. you could have loaded 2 mags manually. Save your money and look elsewhere!

These Ruger Mark II magazines are hard on your thumb when loading due to having to holding down the spring release. This load assistant tool takes about as long to load as by hand. Could have been me but having to pump the clip to get the ammo to drop in the magazine correctly was a disappointment but my thumb is not as sore. They are only $20 give or take so It is up to the individual for value. I bought 2 and gave them away.

I'm not very happy with this loading device, unless you're very careful in lining up the rnds. they can get jammed in the unit

Got the loader today and adjusted it to feed 10 rds into my Buckmark mags. Very easy to adjust and I used teflon tape on the screw to make it tighter. Do not use a spray lube on it. I did and it frosted some of the lexan but the rounds fed easier after it dried.

This item did not work at all, let alone as advertised. I read and followed the instructions, however the device would not load more than one round, it that many. I adjusted the adjustment screw, I tried six different magazines all without success. It took less time to load all six magazines by hand. This item is pretty much useless, except maybe as a target.

I have used this with my Ruger mark iii 22/45 magazines and can shake all the rounds in a couple seconds. Not perfect. Sometimes one gets cockeyed. But it’s fast and easy. Tried with a friends buckmark and it could only feed one at a time and was slower than manually doing it. But I’m satisfied with my Ruger loading.