GoPro Cameras Grab Bag (GoPro Official Mount)

This is a nice little set of various pieces and spare parts that is handy to keep around when you’re trying to build that perfect GoPro mount. The set includes a curved mounting base with 3M VHB tape, a flat mounting base with 3M VHB tape, a standard height mount, an extended height mount, a pivot arm that consists of two pieces, two small thumbscrews, a standard length thumbscrew, and a shorter thumbscrew.If you combine the curved mounting base, the standard height mount, and the normal thumbscrew you have a duplicate of what usually comes with a GoPro camera. Then you’re left with the flat mounting base, the higher mount, and the pivot arm. Combining those parts gives you a nice raised arm that can pivot both back and forth and side to side so you can get a level shot even if you need to mount the base at an angle.The set includes a shorter thumbscrew that can be used when you don’t want the thumbscrew to extend beyond the edge of the camera. This is useful if you are tilting the camera at a 90 degree side angle as it allows a full tilt without the thumbscrew impacting the main part of the mount. The only downside is that the tolerance is very tight and it will be hard to fully tighten the thumbscrew so you may need to use a screwdriver to tighten it down if you need it to be completely locked in place.I mainly got this set in order to get the extended height mount and the pivoting arm. Combining these two things will raise your GoPro about 3 inches off the mounting surface and provide a different perspective versus the standard low mount. I’m using a GoPro mount in my car and the standard mount results in video that doesn’t give a good view of what’s directly in front of the car. Using this kit allows me to raise the camera up higher and angle it down a bit to get more of the ground in front of the car in the frame.All of the pieces seem very sturdy. I’d much rather pay a little more for the genuine GoPro accessories versus having a cheap knockoff fail at a bad time. Highly recommended set if you’d like to add some versatility to your setup!

Perfect, arrived on time

All you need and a must have kit for novice and enthusiasts. Nothing like original equipment that works.

Nice variety of parts that allowed for a variety of mounting situations.

These are a great set of the typical mounts you want for your GoPro. Great backups for other vehicles and applications I need them for with the great quality you expect from GoPro

Materiales de buena calidad quedo conforme Gracias

The media could not be loaded. I love how versatile these hold up. A buddy made a GMRS mount with this. I love it

I've bought non-GoPro mounting hardware before because you can get twice as much stuff for the same money. But it's just not as good. The cheap knockoff mounts are made of inferior, squishy plastic. The tolerances are poor and don't line up correctly.Buy your mounting hardware from GoPro. It's super rigid and everything slots in where it's supposed to and doesn't flop about. You can crank up the tension without worrying about cracking some cheap piece of plastic. It's clearly higher quality.This kit comes with flat and curved adhesive pads, low and high profile snaps, and a 90 degree mount. It includes long and short bolts. I bought it to attach my drone's controller to a GoPro mount on my bike's aerobars. I will be using the curved adhesive pad and the low profile snap. Works a treat.