Elite Controller Replacement Grip Parts – Upgraded Rubberized Left Right Side Rails Rear Handle, Back Panels Faceplates Shell Repair Accessories Kits for Elite Controller (Model 1698)

Perfect fit, easy installation, exact replacement for first generation xbox one elite controller.

My old Elite controller rubber started to peel off of these pieces and there was no good way to stick it back on because of the contours. I found these pieces and easily swapped them out! Just a little bit of prying and they were off, no screws need to be removed to swap these out.

It meets the need and replaces the likely peeling component, but it does have spacing issues in some areas and isn't quite flush all the way around. Overall good product but could irritate people who require perfect alignment.

Near one to one as far as color and different as far as quality very good product!

Got this for the Elite Series 1 due to the other grips going as bad as they do. So I got these even with the reviews about them having a gap. I decided to gamble with it anyway. Finally got them and noticed right off the bat that one of the grips had a broken clip on one of them. Got a picture of them before trying them on. Of course, they have a gap and I am confused about why they have such a gap. The only difference I see between them is these grips seem to be a bit smaller and they are a bit more curved than the normal ones.Pictures for reference. Hopefully, I can figure out something because I was truly hopeful I got lucky and they would fit properly.

These are a perfect replacement. Made the controller look like new again, was very cheap, and easy to replace

Listen to what the other reviewers are saying, I made the mistake of looking at the overall ratings when I ordered. It's really a shame, these look and feel exactly like the OEM controllers, I really wanted these to work out. However there's an excessive gap on the side of the controller that makes holding them uncomfortable. Sending these back for a refund.

Wasn’t sure how to remove the old grips or lack there of at first, but found a YouTube video on how to remove them and it was as simple as it seemed to be. Just gotta pop the old sections off somewhat slowly but forcefully. There may be about a half inch of two sided tape in there holding the original ones in place. Replacement grips attach easily I would say. I’m satisfied with my purchase.