Python Racquetball Replacement Rubber Grip

This grip is awesome. I’ve always used the tape grips but they just shred apart. After my last tape grip lasting three weeks I went with the rubber grip and they have been super durable. I play with a glove so it’s hard to say if they have more or less grip, but at least for gloved play I never noticed any issues.InstallOk so I fought getting these because they looked so hard to instal. The reviews were awful and people whined about tearing the grip with pliers. The grip is not the issue, however the instructions are horrible so it’s more a company issue than a product issue. I found a video that I liked before I purchased and it worked beautifully. All three grips went on in 5 minutes and it was easier than tape.1) peel off the old grip and any glue or tape residue2) take off the wrist band3) put masking tape over the wrist band hole4) stretch out the top of the grip with your fingers so it’s slightly funnel shaped. This will make install much easier.5) coat the grip handle with gasket sealant. Lightly coat the inside of the grip as well. The sealant acts as a lubricant during install and a glue after it’s set. I used gasgacinch and it worked beautifully.6) slight the grip on starting at an angle and straightening the grip out after you get over the knob on the end.7) trim the end of the grip to the right length with a box cutter8) wipe any excess sealant off and peel off the tape9) re-tie your wrist strap, let the glue cure for a day and your good to go!

This grip is a great replacement for any racquetball racquet. The grip has ridges to allowing a sweaty glove to still have a tight grip. Spray WD40 on the inside of the grip and it will slide on with ease. Wait a day and the grip will no longer move on the racquet.

Yes, it took a number of tries to get the handle over the end of the racquet, but somehow, I got it on.I think my grip improved immediately and well worth the time to put it on.

Love the grip when it is installed with proper adhesive. There is no directions or suggestions on how to do this.

Works well to replace a worn grip. I used dish soap for easy installation. After two days the grip still slipped, but after a week the soap dried & the grip did not move. Will buy again.

To apply, remove the factory grip, but leave the sticky tape underneath it. Spray with WD-40 and then roll the grip on. Once the WD-40 evaporates it will stick to the tape and not move.

Hands down, this is the best grip ever! I use it on all on my racquetball racquets and PickleBall paddles. Doesn’t go on easily but lasts forever. I love the feel of it and my sweaty play hand never slips when using this grip.

The u tube directions didn't even start to correctly instruct how to install the 2 grips. I tried everything but no luck. The paper directions said to use either hair spray or wd40. Online they said to use their gasket cement. None of this was in the Amazon site.

Excelente producto, lo he usado ya durante varios años, muy duradero, fácil de instalar.