Gas N Pow3r Melamine Self Adhesive Edging Tape Roll Perfect for Kitchen or Bathroom Cabinets 10m x 18mm - Oak

Did the job nicely. Sticks well. Easy to apply.

This is far better than the iron on trim, would defo reccomend, cuts easy with ordinary scissors. I have had no peel off, it stuck really firm.

Exactly what we needed. Used to cover peeling edges on kitchen cabinets and looks good as new. Don’t think it will last for too long but this is so cheap and easy to put on that it’ll be no problem to redo it as and when. If using to cover peeling cabinets, you’ll have to cut the peeling bits first as they’ll push the tape up and stop it from sticking.

Arrived very promptly, however I was a little dismayed as it's not supposed to be suitable for chipboard, which is what I wanted it for. So I used very fine grit paper on the edges I wished to veneer. Pasted the surfaces and when dried, smoothed them again with the fine grit paper then applied the veneer strip. I must say I'm well pleased with the result. It was reasonably easy to position, as didn't stick fast until pressure applied and was easy to trim with a sharp thin blade to give an excellent finish.

Looks good on my table but comes off really easily and snaps. Wouldn’t buy again as not hard wearing enough.

I wanted an edging for a home-made plywood cabinet but without ironing. This had proved a great solution. Easy to apply, basically like regular double-sided tape it just sticks onto a surface - ours went onto bare plywood edge fine, no primer or anything. I found it useful to cut the rough total length needed with a bit extra, then unpeel and press down as I went along in small increments. Trimmed the excess with Stanley knife. It’s a nice firm, white edge (not quite brilliant white) that gives a professional finish, would use again.

My puppies chewed the edging of my cupboards so I needed to fix them. This worked really well. Stuck on to chipboard perfectly and covered with paint easily. Highly recommend.

Had some unsightly cuts showing the chipboard on the kickboards around the tumble dryer and washing mashine in the kitchen. Found this easy to apply and did the job. It wasn't the exact colour match but unless you get up close you can't see it