200 Pack Irrigation Drip Support Stakes 1/4 Inch Tubing Hose Holder

I use drip regulators attached to 1/2" distribution lines, and then 1/4" tubing to direct to the plant. These are handy for elevating the open ends of the tubes and angling them so I can observe the drip. Makes it easy to inspect for clogs and regulation failures. They work well with both flexible tubing and the more rigid tubing. With the rigid tubing it's harder to keep them in place, but they work.

Used them when installing my drip system. Very sturdy and durability.

works great as described, as little thin and flimsy. Probably brittle in the sun in the long run. For the amount ordered, its easier to pop a new one when one breaks.

The media could not be loaded. Pics compare to one I bought at Lowe's for much more. This really is stiff in only 1 direction. A lot less material, hence the low cost, tried on 1/4" raindrop drip line and it holds fine. Garden was tilled before planting so should be soft dirt and rigidity of stake should not be an issue. Very happy give. Low cost.

These are horrible. Can't get them in the ground. They are so flimsy they bend. I had to cut an inch and a half off the tip so I could get them in the ground.

Great deal on anchor stakes for drip lines. At least as good…if not better than the much more expensive Rainbird or Dig stakes.

Too lightweight. It will not stick to the ground as too light and short to hold the drip hose. See comparison from store bought vs this one.

We needed to anchor soaker hose and drip emitters in our raised beds. These worked perfectly and didn't break the bank. I would buy these again.