SuperDi Copper Flat Bar Stock 1/8" x 1" x 6"- Knife making, hobby, craft, C110-1 Bar

I bought these for making bus bars for my solar battery bank. I have four 12V/200 Ah LiFePO4 batteries that I wanted to connect in parallel to make two 24V/200 banks.These bars can easily handle 400A. Cut to length, drilled two holes in each and insulated with heat shrink tubing. Connected my batteries and gave them a test to the maximum my inverter can handle for 15 minutes. The bars stayed cold and didn’t even warm up with over 120A flowing through them.These are a great solution for custom bus bars. They are a very good value for the price and their terrific performance. 5 stars all day long.

It's copper, just as is described (not Brass as per other review). Dimension is accurate per posting. Works great as a high-current bus bar.

Used this to make a bud bar for electrical project. Worked great.

Used for buss bars in a battery box, drilled an connected 4 wires on each, then used shrink tubing over the whole bar *except where it is bolted to the source)

Some 3/8" acrylic plastic sub-straight and this copper flat bar, drill a few holes for connection bolts and nuts and Viola, positive and negative 12 VDC high current buss bars. Cheaper than any you can buy in the market by far. You pick how many posts you need, what diameter post, even add a small stud for those Power meters and shunts to monitor the battery and consumption metrics.

Great for making your own bus bar for solar panels . great delivery time

Delivered on time as described!

I used this to make a custom ground bar for an antenna. Item was solid copper bar stock.