Question 1

need a laser module,  for use in cutting .50", steel plate, slow rate, ok for application.. please advise.. thank you, mark.¡

Accepted Answer

CNC plasma is your best bet, more affordable and DIY options. Also can set the same table up for CNC Oxy/Fuel cutting as well. Even are options to swap out the plasma cutter for a router to carve and cut wood as well, some have digital hight control to cut uneven material like diamond plate or corrugated steel. And there are options for cutting pipe as well. Many people have made there own and yiu can buy units as small as 2'x2' table cut size or up to 4'x8' and even bigger than that. Some have nesting software that will arrange all of your cuts ro use the least amount of material. And say you have a 4'x4' table but need to cut a 4x8 or bigger sheet of steel, you can cut 4' then slide the steel so it can get the remaining 4 feet and so on. A plasma cutter than can cut 1/2" steel plate cleanly will not cost thst much but I personally would get something that can cut up to 3/4" (or even 7/8" to 1") cleanly. Do not get a machine that can barely do 1/2" or you will be cutting slow and maxing the machine out possibly using more consumables and not having a clean cut (if your looking at lasers I assume you want a clean cut, even by hand using guide steel to run up against I can produce some very clean plasma cuts and CNC can do even better). Dont look at the sever capacity only look at the clean cut capacity and get it slightly oversized. If you want a cleaner cut than CNC plasma can do and any dressing of the material after the cut isnt an option then if you can afford it look into waterjet tables over laser. A benefit of waterjet over plasma is not having thr heat that is associated with cnc plasma or CNC oxy/fuel. I have used hand crank devices that attach to large well casing via a chain and you jabe an adjustable oxy/fuel torch head. You line it up have the large 24" or 30" casing on rollers and you slowly rotate the handle to roll the torch around while rotating the casing in rollers and with this I have seen very impressive smooth and beveled cuts. So CNC plasma will suffice for 90% or more of people out there!

Question 2

Le queda ala máquina atomtrack?

Accepted Answer

Yes

Question 3

I cannot find any documentation on this module. Does it need a laser driver? Do you have any links to documents or recommendations?

Accepted Answer

Hi friend, Thanks for your question.
Please send us the control board of your laser machine directly and contact us. We will give you the appropriate connection.
The reason different customers have different control board and operation software,so it may have some different  operation mode ,we can not give a same manual. Hope you can understand.
Have a good day!

Question 4

Can I attach to Twotrees ts-55 engraving machine?

Accepted Answer

Yes, you can attach it to Twotrees ts-55 engraving machine

Manufacturer	LASER TREE
Part number	450nm 20W
Item Weight	99.9 g
Product Dimensions	11.99 x 5.99 x 5.99 cm; 100.07 g
Item model number	450nm 20W
Size	LT-20W-A
Color	Black
Style	Laser
Material	Aluminum
Item Package Quantity	1
Batteries Included?	No
Batteries Required?	No

LASER TREELaser Engraver Module, 4000mW Optical Power, Laser Engraving Cutting Module, Adjustable Focal, 450nm Laser Head for Laser Engraver Cutter Machine DIY Wood Paper Leather, Class 4

Detalles

Descripción

Presupuesto

¿Tienes una pregunta? Mira lo que otros preguntaron

Preguntas comunes