VEVORPower Benchtop Planers, Three-Blade, Two Speed, 13" Width Worktable Thickness Planer with Extended Infeeding Table, Low Noise for both hard & soft wood material removal

This planer is actually better than we thought it would be. Works great and is very well made. Noise level is not bad.

good value for money. Takes some trial and error to determine how much you can plane in one run but it did the job well. I found two things: 1) a good vacuum/chip sucker set up is absolutely necessary and 2) I made a "landing pad" to avoid snipe as the boards go through. The landing pad prevent the board dropping on the output side and avoids the blades cutting deeper than they should. With those modifications it ran like a champ. I'd give it a 4.5 if I could -just can't give it 5 stars.

4 days of use, worked flawlessly, but you may want to lube the bottom skid plate, I used wd40.

Not a bad machine for the occasional woodworker or the hobbyist. For the price, the performance is quite good and the results meet all expectations.And now for the downsides:1) The manual, while it provides essential information and seems complete, is written with poor English.2) The 'Table Extension' in the back side does not lock in the upward position; You will need a bungee cord to secure it while in storage.3) The vacuum attachment hood gets clogged after a period of use due to the shavings being rather large. This causes the surface of the work piece to get dimpled. I chose to remove it altogether; however, be aware that this action will actually expose the spinning blades, which could potentially be a safety hazard.

The machine is good. The belt broke, I ordered another one. But you can’t get the new belt back on. You are better off buying a higher brand. I did contact the company. They had no answers for me.

Funciona pero le falta power

Absolutely! You should only cut about a hair thickness at a time. Cutter is belt driven part# 6PJ348I thought after cutting 100 ish boards it quit working as I had to push the board threw so I bought a craftsman dual planer lmfao after just 10 boards "hickory " it went dull and the thickness setter vibration kept changing the thickness and the final cut sucked! Vevor 3 blade is a smooth beautiful cut! I did buy some new blades Foxbc so far cuts beautiful. And yes changing the blades is a pain in the butt! But, it's worth it!

The 13”Vevor surface planer purchased thru Amazon is a fine tool for the price. It arrived a day early and in good condition. Virtually nothing to assemble and only a couple minor adjustments.The only complaint l have is that the factory installed cutting knives had no edge and couldn’t plane any type of wood. I had ordered a second set of knives so was able to install them and make the planer usable and have been using it since. It is a very good planer and planes extremely accurately, no adjustments ar all.I am very pleased at the overall unit. I am very disappointed that a quality tool would come with bad knivesInstalled at the factory. Any cutting tool is only as good as the blades or knivesAll in all ,I am very satisfied with the tool.