10W Security Lights with Motion Sensor,Outside Waterproof, 800LM Daylight White 6000K for Garden/Parking/Aisle/Basement etc,Pir Floodlight (10)

The one I received was simply dangerous. The danger only became apparent after opening up.The mounting bracket is very short and will only allow the light to be swivelled downwards by a couple of degrees before the PIR sensor body would make contact if mounting to a flat surface. As I was to mount mine close to the bottom edge of a fascia, I would have been able to increase the downward angle without using a spacer under the bracket.The PIR sensor would not swivel fully from left to right. It would come to about 85 degrees from the left and stop. It would swivel to around 70 degrees from the rear. Turning the swivel 180 degrees around so the adjusters were facing downwards had much the same effect, only 70 degrees from right to left at the front of the light and near 85 degrees to the rear.Taking that part of the assembly apart and realigning would hopefully fix it so left to right swivel was at the front where it should be.After opening the back of the light, I found there had been no attempt to attach the earth wire to any part of the casing. The wire, complete with ring terminal, is just left loose in the back of the box. There was no place to attach the earth to the back box.The rest of the wires are joined together with crimped connectors. The connector over the brown live wires fell off when moving the wires around. The one connecting the red and black slipped off with minimal effort. The blues joined to the black was the only solid connection. The pairs of wires are twisted together and a crimp squeezed poorly onto the connection.The included pictures show the floating earth and fullest travel of PIR front to back, instead of side to side as it should have been.I stood the crimp terminals up in the light fitment to attempt to show down the inside and how poor the crimp action was. The bare wires are just as they were after the crimps fell off.Had there been no problem with the full arc of movement with the PIR, I would not have been aware how poorly constructed and dangerous this light fitment was.

The light has a poor design. The sensor has been designed upside down with the adjustment controls on the top which allows water ingress into the sensor. Every other light on the market has them on the underside of the sensor to avoid this. While it is possible to rotate the sensor head the other way up after removing the cover and adjusting a lock nut it is possible the sensor itself will be upside down in this mode. Setting the sensor to short duration for walk testing and daylight mode even adjusting the sensitivity the light only comes on when your had is waved in front of the light. Absolute junk.The biggest concern if the flex with is labelled and 3 core 0.75mm sq. The flex at the top in the photo is the one provided on the light. The lower one is actually a branded 0.50mm sq flex and the conductor is thicker on this authentic flex than the one on the light. I've no idea what size conductor this flex has (Or even if it's copper) but it isn't 0.75mm sq or even 0.50mm sq for that matter. I have my doubt the flex would stand up to a fault condition within the light itself before failing so this is a safety issue.

Great led light for going above garage to illuminate drive way.Very well made ,easy to fit,very bright.

Just as advertised. Works well.

The cable is shorter than described, over 20cm shorter, not happy as now have to extend the cable by only 20cm, the shortness of this cable, not acceptable.

The sensor does not activate unless you put your hand over it. Having paid an electrician to fit it I now have to pay him again to remove it so I can get a refund.

It's pretty good and cheap, like the cos it git sensor and u don't need more than 10watts led, I use to got 30W but was to bright, 10W now is perfect

Wired them together a regular distances along the drive - really impressive they come on in turn as you approach each 👍🏼