GFCI Replacement Plug Assembly Auto Reset 15 Amp 2 Prongs, 5 Years Warranty, Ground Fault Circuit Interrupter Safety Plug for Pressure Washer, Hot Tub, Air Conditioner, Hair Dryer

Stopped working 2 days after close of return day.Update: I was contacted by the vendor on what they could do. I just wanted a replacement, it was sent and received.They back the product they sell, I happily changed to 5 stars due to great customer service.Thank you very Much!

Large and Heavy Duty. I bought this to fix a hair dryer. This was easy to install and works well. It is very big compared to the original.

I purchased this in an attempt to resolve a power suply issue on my Sun Joe SPX3000 pressure washer following the manufacturers' GFCI plug head not resetting during a project.I was pleased to find out that this plug head resolved the issue and my PW is alive and well.The swap was incredibley simple and I'd strongly recommend this fix before you write off your electric PW.

As described....got it to replace on a hair dryer. Not very difficult to put on and works well though a bit bigger than the original plug. Cheaper than buying a new hair dryer.

Easy-to-install replacement for the failed GFCI on my pressure washer cord. Not sure how waterproof it will be – the rubber around the cord where it enters the housing was very loose-fitting. But cheaper than buying a new pressure washer!

Easy installation and fast shipping!!

I needed a replacement plug for my very expensive hair dryer. I went with this one, 2 prong 15 amp. It's a little larger than the original one. Install was easy enough but I have some tips to make install easier. First make a clean cut of the power cord and then carefully cut away the power cord cover, just enough to get the length of power line you need to reach the 2 posts inside this breaker. Slip on the black rubber sleeve so u don't forget to put it on. Flat sided end toward the new breaker. Trim off enough of the wire cover to place under the wire lugs in the breaker. If you have too much just pull it out and clip a little off with wire cutters. Twist the trimmed wires together, individually making sure no stray wire is sticking out, this may cause a short if you don't do it. Place wire under and in-between the appropriate lug and tighten down. After the 2 wires are connected slide the rubber sleeve up your cord and place bottom half in housing before trying to put the metal wire clip in place. Tighten each screw on the clip a little at a time to evenly get the clip to hold the wire firmly in place. This clip is important, it keeps the wires from getting pulled out. Visually check all wires are in place with no stray strands sticking out anywhere, double check tightness and then put the cover on. Line it up and use your hand to squeeze and hold it together till you get the screws in place. Alternate the tightening of these screws till all are tight and housing is securely closed. Plug in to wall outlet and reset if needed. Red light on housing will be on when plugged in to power and all is good. Install is not hard but take your time, and do it right. Literally took me about 10 minutes to install this. Very happy with it and will update later if it fails. Black wire to the gold terminal and white wire to the silver terminal. Also when your done go back a few minutes later and double check tightness of screws, all of mine turned another half turn.

This replaced the surge protector on my sunjoe pressure washer. Worked perfectly.