NIBBI Motorcycle Intake Manifold,Carburetor Boot Joints,Parts Replacement Manifold Boot For Motorcross Dirt Bike GY6 Engine Scooter

Exactly as described

Nibbi is high quality will buy again from them

Way better than the stock crap they have on there and definitely helps it perform better. A good buy to put on and the company is well known and quality parts

La pieza perfecta que necesitaba mi nieto

So I was under the impression these were race parts. I feel it's race parts because you put a label on it. I am using this on a gy6 platform as intended. I put the gasket kit on and as I put the manifold on the studs it tried to spread them apart. Not a happy camper at all I immediately took all of it off and replaced it back to full oem. I will now and forever buy Taida or NCY parts because I know they function with a higher degree of build standard. I plan in getting rid of all this because I'm done with this Nibbi "race" parts. I also have your electric components and am now worried about the quality of those.

Perfect fit, the original rubber intake kept tearing, this fixed that problem. Looks good too.

I have a Scooter 🛵 with a 139qmb engine. I Have A "Naraku Performance 24mm Intake Manifold Spacer for QMB139" installed to my Naruku V.2, 52.4mm BBK & Oversized Valve Heads. Instead of a CVK Carb, I Use A Nibbi PE Carb & It's Paired With A Nibbi Curve Pipe. Both The Stainless Steel Version & Aluminum Version Mount 👌 To CVT Side Of Scooter....Right To One Of The Holes, The Stock Air Filter Used To Mount To. I just had to make the hole A Little Bigger On The Bracket w/Nibbi engraving, That Comes With Curve Pipe. Add Advertising Says GY6 125cc/150cc, But It Will Work For 50cc, Just Use A Good Gasket or Buy Naruku Intake Spacer (It tapers from 24mm to 21mm). Oh, Be Sure To Invest In Nibbi Throttle Cable, If You Plan On A Aftermarket Nibbi Carb.

For my needs this did not work perfectly had to modify the frame but I'm running it on a GY6 go-kart for a scooter or something with more space it would probably be perfect