Security Camera Mount Bracket, Dome Camera Mount Universal Camera Wall Mounting Bracket/IP Camera for CCTV Security Camera, L Type

No rust no issues after a year of use, highly recommend

Very good…especially for the price. This is used in conjunction with a Reolink camera. As another reviewer stated, you will most likely need to drill a hole in the center of the mounting plate to allow your camera wire to pass through as the factory hole is located on the edge. Just make sure to add the included grommet or electrical tape to the hole for wire protection.

The camera mount works but I recommend a few changes.First thing I didn't like was that the wall mounting plate was not attached to the gooseneck straight as seen in my first picture. The drawings in the product listing indicate that it should be straight. It took additional time to mount the unit correctly.In one of the reviews they mentioned that the screws rusted so I replaced all of the screws with stainless steel screws. The two screws that attach the gooseneck to the camera mounting box as seen in my second picture I used two stainless steel M5-8 screws. The three screws that are used around the camera mounting box I replaced with three stainless steel M4-12 screws.Also be sure to use some white caulk to seal up any openings.I ran the wire through the base plate so I applied duct tape on the cable opening on the gooseneck near the wall mounting plate and filled the hole with caulking. Where the gooseneck attaches to the camera mounting box (see my second picture) there is a gap where water can get in. after I adjusted the camera box and tightened the two screws, I caulked the gap between the gooseneck and the lower camera mounting box.One last issue I noticed after mounting my dome camera and attaching the bracket to the wall was that rain was rolling down the dome on the camera and tripping the motion sensor. A future modification will be adding an overhang rain shield to stop any rain from rolling down the camera dome.I'll also need to see what happens with snow before I install a shield.The camera I used was a JideTech P1 PLUS -5X-8MP PTZ.I had to drill two holes in the mounting plate to properly attach and align the camera.

Although this mount did not fit my camera exactly, it has enough spots to make it work and mount up. Good threading on the screws and good powder coating on the mount. Exactly what the customer wanted and easy to mount.

Most similar mounts won't work for Amcrest dome cameras because most mounts have the wire clearance hole in the center. This has an offset hole suitable for Amcrest, but the hole pattern does not match. I was able to use one of the slots but needed to drill two more clearance holes. It would be nice if the mount had these clearance holes already punched to make it also work for this popular brand of camera.Otherwise the mount is very well constructed and very suitable.

A must when you own a Wyze cam pan v2

If your wires are even a little longer or thicker, they won’t fit. The box doesn’t close properly either. The outer layer feels super cheap, like plastic, and I don’t think it’s going to last long. Honestly, I wouldn’t recommend it to anyone.

Use it for a Riolink camera. Had to modify to fit, but wasn’t a big deal and looks good.