Angelelec DIY Open Sources, Gravity: Heart Rate Monitor Sensor for Arduino, a Pulse Sensor Developed Based on PPG (Photoplethysmography) Techniques, a Simple and Low-Cost Optical Technique

Descripción

INTRODUCTION The heart rate sensor is a thumb-sized heart rate monitor designed for Arduino microcontrollers. It includes a Gravity interface, for easy plug-and-play connectivity. This sensor is a pulse sensor which is developed based on PPG (PhotoPlethysmoGraphy) techniques. This is a simple and low-cost optical technique that can be used to detect blood volume changing in the microvascular bed of tissues. It is relatively easy to detect the pulsatile component of the cardiac cycle according to this theory. The sensor has two holes that you can use to attach to your belt. You can wrap on your finger, wrist, earlobe or other areas where it has contact with skin. The heart sensor has two kinds of signal output mode: analog pulse mode and digital square wave mode. You can change its output mode using the dial switch. There are many user scenarios, including education, sport or maker/interactive projects! Warning yellow.png Please Note: This product is NOT a medical device and is not intended to be used as such or as an accessory to such nor diagnose or treat any conditions SPECIFICATION - Input Voltage (Vin): 3.3 V to 6V (5V recommended) - Output Voltage: 0 - Vin (Analog), 0/ Vin (Digital) - Operating Current: Less Than 10 mA - Dimension: 28 mm * 24 mm, 1.102 inch * 0.945 inch - Interface Type: PH2.0-3P. SHIPPING LIST 1 * Heart Rate Monitor Sensor For Arduino 1 * Wrist Belt 1 * PH2.0-3P Cable