Bosch Professional 18V System Cordless Impact Driver GDX 18V-210 C (max. torque 210 Nm, without battery/charger)

This is a good quality impact, It has Two buttons to tweak the speed and impact. I believe it has bluetooth but I havent installed the app yet to try it.

After a loot of use i can say is a good powerful impact driver. A bit expensive but good.

Ok.

Reviewed 200 not 210. It is powerful and quick, great for new screws, but if the screw is crusted and old it will shred the head of the screw in seconds, it has no speed selector (although the speed is dependant upon the trigger pressure it seems to go from zero to formula 1 starter speed with almost no pressure.)

The end broke off with a couple of week of purchasing and now sockets do not stay attached to the drill. Cannot find a way to contact Amazon to discuss.

One day after using the drill, I started to have issues with releasing the bit from the impact driver, the bits were getting stuck inside the drill, and was very difficult removing it, sometimes requiring some leverage to take the bit out.But not even a month later, when trying to pull the chuck to release the bit, the whole chuck have broken off the driver, which made the bit loose inside and not hold in place at all.The impact driver itself is very powerful and I have no bad words about the performance, it did whatever I threw on it, but sadly I can not recommend it because of how fragile the bit release chuck is and how hard is it to remove a bit.

Brilliant when first bought but despite rare use, it only last 10months before the red release for securing/removing bits broke, rendering it useless.

I love the idea of being able to drive screws and use it as a inpact wrench too. Ideal for the work I do as some days I'd need to use both. Unfortunately I'm having issues changing bits. Example.incould be driving phillips head screws and then need to change to use a 8mm hex head screw this is when I have problems changing bits. When I pull the chuck release it doesn't release the bit I have to fiddle with it and I find putting it in reverse and pulling the release while the chuck is spinning is the only way it will release. I've tried to contact you about it and I've heard nothing back I need this piece of equipment for my work amd agter spending decent money I'd expect it to work as it should. Please help me with advice on what to do and if this is a regular or common issue. Thanks