Chrome Hand Control Switch Housing Caps Compatible for Harley Davidson Electra Street Glide 1996-2013

The first was great I only needed the volume/ mut button as the 21 year old factory installed one fell off while riding!

Fit perfectly on my 2009 SG.

For me, these were unusable. The hex hole that operates the switch was too small and couldn't be made to snap into place. I tried a test fit over the exposed hex stud for the start switch to confirm that they were not a fit. I suppose they could be reworked with a small file, but it was simpler to snap the old caps back on and leave it at that. Someone on the factory line in China must have been having a bad day, I guess. (stamped "Made in China" on the box).

Just as good or bad as HD to install. If your heavy handed or don't know what your doing- don't do it. One side of the switch cap has a "star" side on it that actually activates the rocker switch in question. I've done these before and still at times during the install felt like I wasn't going to make it without one of them breaking. So I won't throw BS at you, its a bit of a tedious install and the plastic is screaming to break just before it gets on the rounded end. Once done and after a few times of use they are fine, the horn and starter button spring are fairly easy to reinstall as long as they don't go flying off when you take it apart.

Ordered them with reservations as you never know what will or will not work. So far they've worked great!

First of all , you'll need a modest amount of mechanical ability to install these. If you have trouble changing your oil you might wanna leave this up to your dealer. I would give this a higher rating, but quality control seems to be lacking. first set I purchased the round holes were slightly smaller than the factory switch caps. Not a huge deal , I took a drill bit the size of the holes on my existing switch caps and opened the holes up . All went well until I got to the last cap.. that last one broke. I'd suggest getting two sets . I consider myself pretty well mechanically inclined so I'm not convinced the break was an installer issue but rather just a weaker cap in the batch. my second set the holes were spot on and the cap installed perfectly. Tip for those who haven't done this before, boil some water in the microwave. let it cool a bit but still be to hot to leave a finger in it and drop your caps in . pull each one out before you install it, dry it off and snap into place. A warm piece of plastic flexes better than a cold onedespite the one broken cap these looked awesome after installation

One of my old switches fell off while riding so I was looking for a quick replacement and ordered these. I only used the push on switches (vol, ptt, mode and cruze) and they fit perfectly on my 08 Road Glide. Nice tight fit. Did not have to enlarge the holes as other people have said.

Great look and finish. For the price.you can't beat these. Fitment is a bit tight. Some of the switches dont rock smoothly as OEM beacuse of this but they still work. Ran into a couple issues after install. The starter switch was just slightly stuck after putting it back together and one the on off switch was flipped the bike immediately would start. Took me a while to figure out the button was being slightly depressed causing this. Was pulling my hair out trying to figure out why. The horn side did the same thing so I shaved the inner side of the housing to give more clearance and it fixed it. Other than that, I'm very happy with my purchase.