Metra 95-7882B Honda Civic 2013-Up Double Din Dash Mount Kit, Black

This was purchased to install an aftermarket double din touchscreen radio. The top is a great fit but the bottom needs a little stretch to secure the screws on a 2015 Civic LX. The radio bezel is more squared than the rounder corners found on the kit. I ended up not using a bezel at all. Overall, it's a workable fit but not perfect

Fits very good in 2013 Honda make the dashboard looks much better.

Exact fit and secures in place! Perfect ! I wish the bezel was removable though.

Works and fits great....the only downside is that once installed the radio faces up a few degrees....so if I'm in front seat the radio face is going up....still for the price it's good

Replaced the HU in my 2014 Civic Coupe and this did the trick.The new HU has a 6.75" screen which fit fine. You could probably squeeze a 7" in there.The body of the HU was just a little too big to fit thru the opening, so I had to enlarge it some. Pretty easy with a little detail grinder. And I'd rather it fit tight than have a big gap around it.Vent, heater controls, and hazard all lined up.Snap in clips lined up pretty well, maybe a little off on a couple, but it still pops into the dash tightly.Matte black finish looks good, almost identical to the factory piece.Overall it's a good product and does what it's supposed to.

Not sure if it’s the particular one I bought but the one I have is awful. The climate controls and hazards button all face slightly downward once screwed in, nothing lines up. There are gaps between the faceplate and the radio, the bracket that mounts to the radio is supposed to act like the OEM radio mount so it’ll reach the bottom bar near the climate controls and mount to it for stability. It doesn’t and cannot. The holes/slots are not threaded AND they’re too big for the oem screws, it’ll never ever work. I had to leave it unsecured. All the while I can hear the plastic rattle under my dash because it cannot be secured. All that and I haven’t mentioned the finish yet, it’s awful and cannot come to close to ever matching the design of the dash at all, it feels like plasti dip that’ll never wear off and permanently attracts finger oils. If you’re putting an aftermarket radio in your 2013-15 civic do not buy this, go OEM Honda nav face plate and then buy the scosche mount for oem nav OR buy the scosche bundle with faceplate and Mount. The scosche one has a much higher quality finish, silver trim part, edges that match the oem. The bracket for the radio behind the scenes is ACTUAL METAL with THREADED holes that can allow you to secure your aftermarket radio properly as if it were OEM equipment.

Product looks pretty similar to OEM dash parts despite being a matte black color. I used this in a 2013 Civic EX with gray/black interior. Instructions are pretty clear (albeit pretty simple) and help with mounting the radio.Despite it looking pretty good, it feels pretty cheap. One of the clips were broken off in the packaging and the entire piece just feels flimsy when compared to the OEM dash kit. Once it's installed, however, it looks fine and blends in very well with the dash.

Fit perfectly and flush in my 2013 civic ex. There was one small piece of plastic that broke off when tightening some of the screws but it did not cause any noticeable damage. I would definitely recommend it !

Muy buen producto y se ve genial

La Radio OEM fit pasIl rentre même pas

Does the trick

I think the material is better quality than the original

It fits fine in my 2014 Civic, just one of the fan screws would mess up the positioning so I left one undone. Should be cheaper.