Xitomer Fender Eliminator Fit For YZF-R25 2014-2024 YZF R3 2015-2025 MT-25 2015-2024, MT-03 2015-2025 Fender Eliminator kits Tail Tidy with Led License Plate Light

super nice quality and sleek design. Fit my 2024 Yamaha R3 perfectly. Very self explanatory and comes with everything you need. I do want to mention the LED light it comes with sits at an odd angle on the plate. It is sitting up a bit being a tad bright for drivers behind you. I had to bend mine up a bit due to my bike being lowered a bit. Aside from that it looks great compared to before. Thanks!

this was a great addition to install on our R3. the old one came out with 4 nuts and the new one went on with the new hardware. its nice to eliminate the old bulky plate holder. the plugs are not direct fit so you can solder or do what i did, i slide the round plugs over the balded male and taped it with tesa tape so it wont move and works great. rather do that then cut wires.

This is a must! Just wire the tailight wires through the plate holder and bike before bolting it on. Also the hole for the tailight needed a tiny bit of going to make the connector fit through but no big deal!

I haven't seen a confirmation on if this will fit a 2024. Well this is your confirmation. It fits the 2024 model and looks so much better than the stock fender. All hardware was included. The only splice you will have to make is the plate light. The stock one doesn't fit so you must use the one that's included with the kit. You will also need a file or Dremel tool to clean up the turn signal mounting holes after you pop out the insert and to enlarge the hole for the wires so the stock cable connectors will fit.

I am revising my review because the supplier saw my rating (2) and immediately contacted me by email to explain what happened and make things right. They had recognized the problem I reported and corrected their design, but unfortunately, their inventory is controlled by a third-party vendor and they have had difficulty in purging the old, wrong design from inventory, so sometimes the bad parts still get delivered to customers (like me!). They sent me a new part for free, but as luck would have it, it was still the old design. Nevertheless, I give them kudos for their customer focus and attempt to make me happy. Like I said in my original review, it is still a very nicely made part and I'm sure that the corrected design is good. Dinged them 1 star due to the failed attempt.--------------original review follows---------------The part was beautifully fabricated and finished, but was not bent to the correct angle, so the license was nearly horizontal instead of being more vertical, so it can be read properly at a distance. I had to devise a way to clamp it in a vice and bend it as far as I could without causing it to crack. I also had to modify it to accommodate the original tail turn signals and license plate light. It turned out great, but if I hadn't had to rework the part, I would have given it five stars. I hope the manufacturer reads this and modifies their design accordingly.

Works perfectly for 2025 r3 even retained oem led signals

I got this for my MT03 and we had to do so much cutting and modification to this in order for it to actually fit. It was just one problem after another, I would’ve just bought an entire different item if I knew this would be the case but at this point my bike was already disassembled….Very poor item fitment and creation… wish I knew this before

Looks great on the bike and the night is bright enough, weight is questionable and a nightmare to install… all of the bolts had threading issues, two snapped trying to screw the nut in after they got halfway and got stuck. The hole in the middle isn’t big enough for blinker harness to fit through. Little thicker than it needs to be but functionality is good. The stock blinkers went in fine but the removal process is tedious, they want you to use a key to bend a metal piece until it breaks off leaving behind two really sharp bits that need to be filed down.